\L298N H-Bridge Motor Driver Shield
This Arduino shield is based on the L298N H-bridge driver chip.
You can use this shield to drive two DC motors or one four-wire two-phase stepper motor. The power terminal on the board should be connected directly to a power supply that is capable of driving your motor. It is good practice to try separate your motor power supply as much as possible from your Arduino’s power supply. You can use separate power supplies if you need to but you must connect the 0v(gnd) signals from each supply to each other. This should be done with separate wires and as close to the supply as possible.
The header pins are included with the shield but are not soldered in place.
This product comes with the following:
- L298N H-Bridge Motor Driver Shield x1
- 2.54 40PIN Male Header x2
- 2.54 8PIN Female Header x2
- 2.54 6PIN Female Header x2
- Arduino stackable header kit x1